Features :Supplies a standard line output from a speaker high level input, as from arear speaker connection on the receiverConverts from 10 to 30 watts per channel RMS with a fixed 10:1 conversionratioLinear from 20-20,000Hz at +/- 5 dBMaintains signal phaseCompletely shielded from noise & vehicle interferenceAdapts floating ground systems to common groundsBuilt-in load resistors allow for full fader useIsolates input and output circuits to prevent ground loop noisePerfect when adding an amplifier to a factory or aftermarket radioGreat for getting an additional set of pre-amps outputs from a head unitequipped with only one set
Average Customer Review:
( 5 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
2 of 2 found the following review helpful:
Works as intendedJan 15, 2014
By Ryan Knights Nothing special just a line output converter to convert your stock headunit in your car to have RCA inputs. I hooked this up in my Jeep Wrangler and it was small enough to fit perfectly behind the headunit without rattling and does exactly what it is intended to do. Quick and easy installation and now I have a perfect sub for bass in my car.
Other options...Sep 25, 2014
By John I comes with ground lines you may have to find. The best way to do this is just cut a normal RCA audio line and use the center as positive and lines around at negative. Some RCA lines have a positive and negative separated....but either way they should work fine if you know how to play with wires appropriately.
Great ProductAug 05, 2014
By Derick Word fine and fit no problem. Cheapest place I could find this so get it here if you need this
0 of 1 found the following review helpful:
IT WORKEDMar 22, 2013
By dimas velasquez WORKED WITH A MANUFACTURED STERIO WITH NO RCA JACKS.... OK OK OK OK OK OK OK OK OK OK OK